Transducer Shield For Humminbird HX 14 HW CMSI T

Transducer Shield For Humminbird HX 14 HW CMSI T

TM-CMSI-7.1 is built-in High-Quality Alloy and Black Powder Coated.  It is designed to fit Humminbird TM-MCSI-7.1. The Sleek Hydrodynamic Design will cut through the water for less drag, especially on trolling motors. It reduces collection of debris, keeps the transducer positioned correctly and will not interfere with the transducer signal.

NOTE: When the transducer is attached to a Set Back, Hole Shot Plate or the side of a Jack Plate, it will not track the bottom when up on plane because the transducer is out of the water. For bottom reading on plane, a transducer inside the hull will be required.

CLICK HERE: to identify your transducer Humminbird Mega & Solix transducer

For trolling motor installation, two clamps/straps are required and are not included with the Transducer Shield.

Installation:

The TM-CMSI-7.1 is designed to easily attach to one of the TSS L Brackets or Wedges for Jack Plate, Hole Shot Plate or Set Back installation. When purchasing this item to attach to your jack plate, please check out the:

- L Brackets for install on the side of the jack plate

- Wedges for install on the hole shot plate under the jack plate

- Wedges for install under the transom set back – if your boat does not have a flat set back, this is not a good option for you.

- Spring Back Bracket SBB-5 to install the transducer on the transom (if you do not have a jack plate)

- Armor Plate AP-DS-8.4 this is in addition to the Spring Back Bracket

Proudly Designed and Built in the USA